Nanjing Insbud Controls Company Limited
Main products:Thermostat,Valve,Sensor,Controller,Air Damper
Products
Contact Us
  • Contact Person : Mr. Wu Stephen
  • Company Name : Nanjing Insbud Controls Company Limited
  • Tel : 86-25-68552691
  • Fax : 86-25-68552689
  • Address : Jiangsu,Nanjing,4th Building,No.88 Siemens Road,Jiangning Economic Development Zone
  • Country/Region : China
  • Zip : 211100

motorized valve & Sweat valve & on/off valve &spring return valve

motorized valve & Sweat valve & on/off valve &spring return valve
Product Detailed
Sweat valve equipped with on/off electric actuator to control the flow of hot or chilled water.

Material : brass

Pipe thread :1/2", 5/8", 3/4", sweat type

Valve type: normally closed 2-way /diverting 3-way

Supply Voltage: 230VAC; 120VAC; 24VAC

Operating pressure: 300 psi / 2.0 Mpa

Norminal pressure: 233 psi /1.6 Mpa

These valves are compact units consisting of small Electric Actuator and 2 / 3Way Valve for controlling the flow of water or any liquid that is not injurious toBrass. These valves are designed for use in Fan Coil Units or any other systemrequiring quite and compact water lines.

Design Features

The valves are supplied complete with actuator that can easily be installed.The housing and the cover are made of metal.A flap made of special rubber is used as the element to provide absolutely tightshut-off. Two O-rings are used to seal the spindle.The motor opens the valve electrically and closes it by means of springs.Faulty actuators can be replaced without removing the valve form the pipe work.Auto/manual lever which allows manual operation at power failure.

The valve installation must be done by a trained experienced technician only.The rating given on the valve should be checked and confirmed suitable forIine use before installation . Install the valve in on area with adequateClearance , so that the manual opening lever on the body can be moved freely.It can be mounted in any position on vertical pipe line . If it is mountedHorizontally . The power head must be even with or above the center line ofThe piping . Always ensure that enough space is provided above the powerHead to remove the cover for servicing.NOTE :- THIS IS A SIMPLE DIVERTING VALVE AND CAN BE USED INANY WHERE THERE IS A REQUIREMENT FOR DIVERTING LIQUID , THISVALVE IS ONLY MEANT FOR USE IN LIQUID .

motorized valve & Sweat valve & on/off valve &spring return valve



Copyright Notice @ 2008-2022 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.